Archived

This topic is now archived and is closed to further replies.

TMX Pro stuck calibrating

2 posts in this topic

I have a used TMX Pro that 99% of the time seems to be stuck in calibration mode.  I've tried updating firmware and it only shows version 11.  Seems that there should be higher versions from what I've been reading.  This doesn't seem to have a hall effect sensor on the motor.  So no idea how it figures lock to lock or how to troubleshoot it.  Any ideas where I can start with this?  Or just easier to replace it?   (Realized I mistakenly called this a TX wheel, it's the TMX.  Which is why no hall sensor...)

Thanks,

Tim

Share this post


Link to post
Share on other sites