divan00 0 Report post Posted September 6, 2015 Hello fellow simracers! Yesterday I got my Buttkicker Gamer 2 and I immediately attached it to my Obutto Ozone. Anyway, I can't get it to work with Dirt rally... Everything is setup correctly as far as i know. I can launch the game, and when the game is running it is saying that in simcommander. I still don't get any vibrations. I have all effects on just to be sure, but nothing is coming to me Anyone else had this problem? Would be fantastic if someone in here could help me! Cheers Share this post Link to post Share on other sites
Junkie 11 Report post Posted September 6, 2015 Go to the SImXperience website,there is a file in the game you need to change to get it to work,or look up posts made by Avenga on this site. He is very helpful on getting this to work. Share this post Link to post Share on other sites
Darin Gangi 1,074 Report post Posted September 6, 2015 It's actually here too: http://www.isrtv.com/forums/topic/17665-accuforce-and-non-supported-wheel-fix/page-2#entry178644 Do all the fixes that Avenga recommends including this one: http://www.isrtv.com/forums/topic/17665-accuforce-and-non-supported-wheel-fix/page-2#entry179541 Also, make sure that Sim Commander is pointing to the right Steam directory. Share this post Link to post Share on other sites
divan00 0 Report post Posted September 7, 2015 Go to the SImXperience website,there is a file in the game you need to change to get it to work,or look up posts made by Avenga on this site. He is very helpful on getting this to work. It's actually here too: http://www.isrtv.com/forums/topic/17665-accuforce-and-non-supported-wheel-fix/page-2#entry178644 Do all the fixes that Avenga recommends including this one: http://www.isrtv.com/forums/topic/17665-accuforce-and-non-supported-wheel-fix/page-2#entry179541 Also, make sure that Sim Commander is pointing to the right Steam directory. Thanks a lot for the information! I got my Buttkicker to work now! Share this post Link to post Share on other sites
RaceNut 40 Report post Posted November 18, 2015 I can get Dirt Rally to work with SC4 just fine but, it stops working after one session. The only fix I've found is to reset the DR profile in SC4 but, then I lose my settings and have to start from scratch again. I've also tried exporting a working custom profile and then importing later - doesn't work. I also tried uninstalling (100% clean, registry, folders, etc.) / re-installing SC4 with the same results. Any ideas? Update: After further testing, the issues appear to have been caused by an older driver for the Realtek on-board audio used to drive SimVibe. The Fanatec CSS SQ shifter does have a calibration problem and support will be issuing an RMA for repair. Share this post Link to post Share on other sites
