How to prevent Wheel Stand Pro sliding on laminate floor?

[Bloodycut 11]

Any good tips how to prevent this sliding movement when braking? I'm using Basherboard brake mod (one red and one purple bushing) and when I'm braking wheel stand starts moving forward. Laminate floor is quite slippery. I have looked also under rubber parts which are against floor and they are ok. Do you have any stoppers to increase friction? My pedals are F1 position.

[SteveS 1,391]

 I replaced the rubber mounting points on the wheel stand but that did not help much. I found I needed to fasten/anchor the wheel stand to the chair/seat...

[Andrew_WOT 66]

1) Wipe the rubber stoppers with some wet rag and rub them, any dust decrease friction.

2) Put a piece of rug carpet gripper under http://www.homedepot.com/p/TrafficMASTER-8-ft-x-10-ft-Premium-Rug-Gripper-Pad-380-1/203199010?N=5yc1vZb8e0

[Bloodycut 11]

Perhaps I buy carpet gripper. How would help if I shorten lower pipes under pedals?

[stone775 173]

HI Bloodycut, I won't cut the pipes down myself. I would do just what Andrew_WOT said to do, with that carpet gripping stuff and just set the Wheel Stand Pro on it and IT Won't move under regulator braking.

[Bloodycut 11]

Ok, I meant about shortening distance from Allen key holes, not cutting hehe. I just look out our local furniture shops those carpet grippers, nice prices. Thanks for advices guys.

[Bloodycut 11]

Just add a little bit new information...I add car rubber mat of car under stand and now I could at least put two purple bushings under brake pedal. I like hardcore braking. At curves it helps a lot when it's necessary to brake shortly. Sadly there is no available Bodin's  load cell mod at a moment.

[Niki Lauda DK 1]

I have a thick carpet and a strap to hold the wheelstand so braking isn't a problem anymore. No sliding at all.

 

[Bloodycut 11]

Next tip: put door stoppers under front rubbers. Works for me. I have also rubber carpet. Wheel stand pro bolts are going to loose sometimes and I gotta tighten them. Hardcore braking with DSD pedals do this. Should I buy next wheel stand or cockpit? What do you suggest?