Search the Community
Showing results for tags 'emergency brake'.
Found 1 result
hi guys, I have an issue that has me stumped. I have been trying to wire up a hand brake on my Logitech G27 by following a few guides like the one i have linked below: i have soldered the board twice and backpedaled out after the software driver failed to detect the controller correctly in windows. removing the mod restored the system to a working condition. One thing that i'm not entirely sure of is how the hand brake needs to get wired up on its side and I'm not finding many resources to guide me on that subject. I'm currently trying to use the led light switch that is on the hand brake. the switch is actuated when the brake is pulled to create a circuit. I connected the wires to opposing sides. I then ran one side of the switch to each solder point on the board outlined in the video above. here is a picture of the hand brake led light switch i tried to wire up for the mod. The brake is currently in a down position, however if pulled the screw makes contact with the other side of the switch completing the circuit. FYI, the hand brake I am trying to use was pulled out of a scrap yard from a Volvo s60. Any input would be greatly appreciated. Thanks in advance!