-
Upcoming Events
No upcoming events found
Sim Racing Discussion
Here's where you can post general sim racing related discussions as long as they are polite and constructive. Please refer to the specific sections and sub sections for topics and discussions
1616 topics in this forum
-
- 12 replies
- 2923 views
-
- 4 replies
- 2330 views
-
- 0 replies
- 192 views
-
- 0 replies
- 139 views
-
- 0 replies
- 112 views
-
- 1 reply
- 217 views
-
- 2 replies
- 297 views
-
- 0 replies
- 153 views
-
- 0 replies
- 219 views
-
- 14 replies
- 1653 views
-
- 1 reply
- 405 views
-
- 0 replies
- 256 views
-
- 5 replies
- 2023 views
-
- 2 replies
- 151 views
-
- 15 replies
- 1156 views
-
- 2 replies
- 309 views
-
- 2 replies
- 327 views
-
- 1 reply
- 225 views
-
- 0 replies
- 175 views
-
- 5 replies
- 327 views
-
- 1 reply
- 335 views
-
- 0 replies
- 306 views
-
- 2 replies
- 319 views
-
- 8 replies
- 1143 views
-
- 2 replies
- 231 views
Announcements
-
Posts
-
-
-
I pmed you with my email. i ll send via email those pics. I cant post pics as my account need cleanup of old posts ... -
By Tillmander · Posted
Can I see pics of the pedals, please? -
1 Ground the rig . Create a wired connection to a diy plug. Plug it to a grounded socked on your wall. Make sure your electrical socket on the Wall is actually grounded properly. do that check with a voltmeter (sometimes that s not the case if done by a lousy jobber) 2 Ground the DD wheel , especially the motor with a wire to the rig or to a wall socket 3 ground each device , to avoid flickering etc that should be enough. PS the Dennis Reimer usb mod is ok as long as your rig is also properly grounded . what it does is make a connection between the shield and GND of the device to the GND of the rig that is also grounded. in a nutshell everything should be connected to the electrical wall socket GND one way or another...
-
-
Topics
-
-
Popular Contributors
-
Who's Online (See full list)
-
Member Statistics
-
Recently Browsing
No registered users viewing this page.
