-
Upcoming Events
No upcoming events found
Motion Hardware and Software Discussion
This section is designated for discussing motion hardware and software whether it's DIY or companies that provide motion products.
98 topics in this forum
-
- 21 replies
- 7086 views
-
- 4 replies
- 396 views
-
- 6 replies
- 2448 views
-
- 2 replies
- 339 views
-
- 0 replies
- 515 views
-
- 0 replies
- 334 views
-
- 1 reply
- 775 views
-
- 0 replies
- 346 views
-
- 23 replies
- 3788 views
-
- 22 replies
- 1989 views
-
- 0 replies
- 542 views
-
- 13 replies
- 3724 views
-
- 5 replies
- 1480 views
-
- 30 replies
- 8364 views
-
- 0 replies
- 483 views
-
- 2 replies
- 612 views
-
- 0 replies
- 633 views
-
- 0 replies
- 360 views
-
- 0 replies
- 445 views
-
- 0 replies
- 486 views
-
- 3 replies
- 704 views
-
- 3 replies
- 866 views
-
- 0 replies
- 596 views
-
- 0 replies
- 1064 views
-
- 1 reply
- 829 views
Announcements
-
Posts
-
-
-
I pmed you with my email. i ll send via email those pics. I cant post pics as my account need cleanup of old posts ... -
By Tillmander · Posted
Can I see pics of the pedals, please? -
1 Ground the rig . Create a wired connection to a diy plug. Plug it to a grounded socked on your wall. Make sure your electrical socket on the Wall is actually grounded properly. do that check with a voltmeter (sometimes that s not the case if done by a lousy jobber) 2 Ground the DD wheel , especially the motor with a wire to the rig or to a wall socket 3 ground each device , to avoid flickering etc that should be enough. PS the Dennis Reimer usb mod is ok as long as your rig is also properly grounded . what it does is make a connection between the shield and GND of the device to the GND of the rig that is also grounded. in a nutshell everything should be connected to the electrical wall socket GND one way or another...
-
-
Topics
-
-
Popular Contributors
-
Who's Online (See full list)
-
Member Statistics
-
Recently Browsing
No registered users viewing this page.
